Hydrium Building

Hydrium Building

Building features:
- Elevator included
- 14 floors
- Helipad
- Roof top pool
- Balconies on most floors
- Unfurnished

Perms: Mod, Copy, No Trans (all scripts are copy only)

Land impact: 210 LI

Size: 38.25m x 50.25m x 221m (heigh), it fits well on a 4096 sqm land

Installation :
Just rezz the (rezzer) in the center of your parcel (a 4096 sqm minimum) click it and select build, then when its done you could move or rotate the tower by moving or rotate the rezzer if you need so. (i strongly recommend that you move slightly the rezzer after build is rezzed, doing that will fix any part that didn't rezz well) .

When your satisfy with the position, to lock it in place click the box and select done, doing that will remove position scripts in the build so you will no longer be able to move it with the rezzer.

Using the elevator:

Click the green button on the controller box nearby the elevator on ground floor, it will open a setup page, on that web page you could if you wish (not required) setup a password but you could as well click on continue without a password, (don't take too much time otherwise you will have to click the green button again)
Click on the green box Initialize on the web page, wait 30 sec so the download finish then click the [Gentek] Delta Elevator Car (Single) v1.0.6 box then click below that the button Connect & Configure, you will see all the floors setup, then click on Save & Start and close the web page , your elevator is ready to use.

To call an elevator you must be at an arm distance from it (like in rl).

Note: If you rezz more than one building containing a Gentek elevator, you will get this message '' [Gentek] Delta Elevator Intercom v1.0.6: You have rezzed another intercom phone. This intercom phone will now be deleted because only one intercom phone per region is supported.'' It's a Gentek issue, nothing i could personally fix.

Have fun with it, for support just send me an IM

Carl Landfall
Incubo Design