Display a flag or logo on a flag pinned to a wall or doorway. The models are single or double-sided so you can show both sides.
Materials layers included for shading, shine and bump.
Low land impact - just 2 prim equivalent!
100% Original Mesh
See item in Second Life- Low Land Impact - just 2 prim equivilaent
- Materials textures included
- Single and Double-sided included
- 100% Original Mesh
- Full Permissions
Perfect :)
This was just what I was looking for - I had to mod my national flag a little to make it fit within the bounds of the flag, but it turned out perfect!
Magaling!
Realistic and Optionally Only 1/2 LI
This flag is made for hanging as a drape on a wall (not as a flag on a post) and comes with tacks. In RL, the tacks would be probably placed in the corners. I felt that it looks better without them altogether. Unlink them and the flag drops from 2 LI to 1 LI (actually 0.5 LI). The gentle roll at the top and edges immediately brought my flat flags to life.
The texture size can be easily set by setting the scale numbers to:
Horizontal Scale: 1.0
Vertical Scale: 1.75
Vertical Offset: 0.30
Remember to synchronize materials for best results.
Linking my two flags together gave me an LI of 1.0, which provides a vast improvement over my flat prim flags at no additional cost.
This is good
It looks good with reliefs as I expected, the only thing I can say in Cotnra that this uses templates, so you will have to make the flags through them or try to fit with a little patience and luck
