[Air-Fire] - [Zero Gravity]

First Fully Mesh Hover Board

-Air Fire- (Escape Your Boundaries)
---------------------------------
Unique And Easy To Learn
One Of The Best Flight Systems
Also Easy Hud Manipulation
The Board And Hud Is Copy Modify
Alter A Board Save It And Rez It When You Like.
Preform Amazing Light Shows In The Sky With Your Friends! Stunts And Tricks Included

Board Features
-----------------------------------------------
-Includes High Definition Sounds.
-Two Plasma Jets on/off Buttons.
-Burn Plasma Tracks In The Sky.
-Rez and Derez your board Buttons.
-Five Tricks and stunt controls.
-Various Hud Sounds
-Avatar Lean Movement.
-Shifts your Weight to Maneuver.
-Color Changing Plasma Buttons.
-Carry your board Button.
-New] Fly With a Friend!
-New] Hud Performance Scripted
-New] Lag Performance Issue Resolved
-New] Particles Now Change With Color Of Board Properly
-New] Hud Changes Color With The Board
-New] Hud Button 2 Speed Toggle Switch High - Low
-New] Hud Button Dynamic Camera Control - Very Cool
-New] Hud Now Displays Current Speed Of Board While Flying
-New] Stunt Full Looping Forward + Back

Controls
-----------------------------------------------
Forward Back Left Right Up Down and while holding shift.
Using these in different combination's will allow you to preform stunts.
Forward and Back will stabilize your board.
Tap on the forward key once after pressing particles on to enable the
stream also with the color buttons.

Extra Help
-----------------------------------------------
How To Replace The Board With The Refitted Height?

1 First stand on your board.
2 Open the build menu then select edit linked parts.
3 Then press (Ctrl - Alt - T) to view the little red prim above the board
4 After you can see the square prim select it then pull it up or down
with the blue arrow to adjust where you stand on the board.
5 Stand up off the board and then back on to see the results.
6 Once your set on the placement, take the board you just adjusted into your inventory.
7 Then go back to the build menu and select edit linked parts after dropping the Hud.
8 Select the rez button on the hud .
9 Delete the current board inside the rez button.
10 Then place the adjusted board inside of the rez button.
11 Done.

-----------------------------------------------
Also you can setup which color you want to start with on rez.

1. Rez The Hover Board.
2. Select which color you would like on the Hud.
Optional. Modify the entire board.
3. Take the modified board into your inventory.
4. Drop the Hud.
5. Use alt to zoom onto the rez button.
6. Open your build tab.
7. Select edit then check edit linked parts.
8.Select and open the contents of the rez button prim.
9.Delete the old hover board.
10.Now place the modified board inside the button.
11. Wear your hud.