取扱説明書
YAMATOFACTORY ベンキシリーズは非武装の遊覧飛行専用の飛行機です
●下記の操作は全て機体から取得できるHUDでも行えます。
●フライトモード切替（デフォルトはクルーズモード）
"d"=フライトモード切替。
*クルーズベンキモード
*アクロバットベンキモード
●その他にに関する設定。（デフォルトは全てOFF）
（注意エンジンをstartさせる前のみ変更できます。）
* "mode stall on" =失速の有り
* "mode stall off" =失速の無し
* "mode lh on" = 高度の影響を受ける
* "mode lh off" = 高度の影響を受けない。
ーー機体の操作関連－－－－－－－－－－－－－－－－
●エンジン始動
* "start" = エンジン始動
* "stop" = エンジン停止
●機体の制御
↑=機首を下げる
↓=機首を上げる
→=右に傾ける
←=左に傾ける
●機体の出力の制御
Page Up =出力Up
Page Down=出力Down
●その他の操作
* "c" = パワーウォシュレット
* "g"=ランディングベンギア OPEN
* "cam" = 外部カメラビューに切替
* "cam n"(n = 0 to 5) = 外部カメラビューの視点が変わります。(１～５)
●直接ベンキをtouch
*蓋=開閉
*水洗レバー=水洗
--ゲストベンキモードに関して---------------------------------------------
HUDの（設定）より、ゲスト設定をONにすることが出来ます。
ONにすると、次に座る人に操縦権が与えられ、降りると飛行機は失われます。一度設定をONにするとOFFにすることは出来ません。
（OFF状態に戻す場合は、機体を出し直してください。）
=============
FEATURES
=============
●All can be operated also with HUD as follows.●
=============
CONTROLS
=============
Two different operation methods can be switched.
The default control is "Cluise-MODE" and can be switched into "Acrobat-MODE" by saying the command "d ". (Acrobat-MODE =excepting large airplane)
See also the section "COMMANDS".
<< Acrobat-MODE >> (Option)(excepting strategic bomber)
* [LeftArrow]or [RightArrow]= Roll-left or Roll-right
* [UpArrow]or [DownArrow] = Nose-down or Nose-up
(!) You needs 2-stroke key pressing for turning to the left/right. The first is to incline the airframe to left/right. The second is to pull the nose.
(!) You can fly freely with your advanced flight technique. For example "Immelmann Turn", "Aileron Roll", and so on.
<< Cluise-MODE >> (Default)
* [LeftArrow]or [RightArrow]= Turn-left or Turn-right
* [UpArrow]or [DownArrow]= Nose-down or Nose-up
<< Common Operation >>
* [PageUp]or [PageDn]= Throttle up or throttle down
* [LeftClick (on the airplane)] = Switch the camera angle to next position
* [LeftClick (on the lid)] = Open/Close the lidy
=============
COMMANDS
=============
Sit in the cockpit, and say following commands through the chat.
<< Engine >>
* "start" = Start the engine
* "stop" = Stop the engine
<<Flightmode chang>>
* "d"= Acrobat-MODE (excepting strategic bomber)
* "d"=Cluise-MODE
<<mode select>>
<< Functions can be used while the engine is inactive >>
* "mode stall on" = Activate STALL function.
* "mode stall off" = Deactivate STALL function.
* "mode lh on" = Activate HEIGHT-LIMITATION.
* "mode lh off" = Deactivate HEIGHT-LIMITATION.
(Default : OFF)
<<Guest mode>>
The person who got on after the guest mode is active can pilot the
plane only once.
<< Functions can be used while the engine is active >>
* "c" =Seawater jet
* "cam" = Switch the camera angle to next position
* "cam n"(n = 0 to 5) = Switch the camera angle to the specified position directly
* "g" =Landing gear
==================
FUNCTION
==================
<< STALL >>
If the STALL-MODE is active, an intense control or a slower flight occur stall.
If the HEIGHT-LIMITATION is active ,to fly high height occur stall. Because flying higher decrease the speed.
(Default : OFF)
* "mode stall on" = Activate STALL function.
* "mode stall off" = Deactivate STALL function.
<< HEIGHT-LIMITATION >>
If the HEIGHT-LIMITATION is active, you cannot fly higher than a certain height.
The more the airplane rises to the higher sky, the more the effect value of the engine power decreases.
* "mode lh on" = Activate HEIGHT-LIMITATION.
* "mode lh off" = Deactivate HEIGHT-LIMITATION.
(Default : OFF)
