Trap Script
-------------
- Turn any mod-able prim into a Avatar-Trap
- Notification when victims is caught and released
- Automatic release after a while (settable)
- Adjustable range & catch-time
- List of Operators
For a full functionality, the victim must use the RLV
http://www.erestraint.com/realrestraint/
If you look for the same functionality without trapping,
you might have a look here.
Functionality
--------------
When a victim (which uses RLV and wears an active relay) stays long
enough near the device, the victim will forced to sit on the device.
In addition, the victim will become unable to stand up until the time
is up.
When the victims stands up and does not leave the range of the device,
it will get caught again.
Whenever someone sits or stands up, a notification is sent.
Installation
-------------
You have to put the three scripts (trap, sensor and reload) into this prim
of your device which contains the sit-scripts also. Usually this is a poseball.
For your convenience they are delivered in a simple bar-stool.
Configuration
----------------
You can configure this script by a notecard named 'settings'
Following definitions are usable:
IM=<avi name> The name of the avi where notifications are sent to.
LOCKTIMER=<n> Minutes how long the victim has to stay.
WAIT=<seconds> This is the time between two scans. If an avi is found
two adjacent times in the range, it will become a victim.
RANGE=<meters> The range where the device looks for victims.
