[SM] Air Track Connection Kit

SM Air track Connection Kit

With this kit you can make a air track to connect to your other tracks, above or below.
The track parts are in general up going parts and is the whole point with this kit.

It contains a pre-made spiral as you see on the picture. this whole spiral you can copy on top as many times you want or your SIM allows it.
beside the spiral, there is other parts so you can move around the area to get to your next connecting point.
All parts are covered with walls. They are set to 80% trans so you can easy connect them before you make the walls 100% trans.

My advise is to start with the spiral on the bottom track and copy it on top a few times. When the normal view from ground is out on site, start using the other parts to get the connecting point. This way you get a more clean and nicer air track view from ground and let it get all messy up at the bottom of the other track, where its out of normal view.

You don't need any add-ons. Its all set for you when you build with it. It have walls. Just needs small ajustments connecting track and walls.
Of course you will need to make way through your track(s) for a final connection. This here kit just provides you with air track to get from one track to a other.
There is a rock guard on each part and is just there for view. Its good for better focus on track turning when you drive.
BUT you can remove it without spoiling anything. Its just for view.

The whole kit comes with copy, mode rights. Means you can of course change the textures.
All the textures on the kit is just demo so you can see it full set up and is not incl. in the kit. But the parts is textured as you see them when you buy.

There is no prim info, becouse it is really endless due to how much you will be building with it. But the track parts it self is from 1-11 prims.
If your familiar with building, you find it very easy kit to work with. Its just copy, copy , copy, place, place, ajust walls, set 100% trans, connect.
done ready to use.

if you like to see it out before buying, just IM me and figure it out.

DATA:
Track parts is MESH and range from 1-11 prims
Guards are sculpt and uses 1 prim each track part set. (They need to be phantom and cannot be linked to the track part or walls.)
Walls is SL prims. (when set, edite the walls ONLY, ajust and finish by setting them 100% trans under "Texture")
Textures: All parts comes textured as picture shows. Textures is not incl.
Rights: Copy, Mode

Best regards
SIMBAZ MOTORZ
Simone barsov