Small zip line with easy automatic installation.
The zip line consists of the base and the stop station.
The rope and the small seat are rezzed automatically during installation.
Content:
Base station 2LI mountain station
Stop-Station 2LI valley station
The installation takes place after setting up and aligning the mountain station and the valley station.
The distance between the stations must not exceed 100m.
You click once on the base station and you get a menu
Then choose "Start"
The rope appears and aligns itself automatically. Then the small seat of the zip line appears.
After a few seconds, the owner receives the message:
Installation complete.
That was all and can be done in a few minutes. If everything is in the right place and works perfectly, click on "DONE" in the menu. This deactivates the installation scripts.
If you want to change the location of the installation, simply delete everything and reez the stations from your inventory.
A film from a satisfied buyer,
Thanks for the film
https://www.youtube.com/watch?v=_Mi88_ETOEk
The stations are copy and modify.
The scripts are no modify
If you have any questions, the creator is available to you. Just write a notecard and send it to babilonto Karu.
Average
good item, but the textures are too old and pity that the range is limited to 100 meters
Awesome
Does the job and does it well. Thank you!! Super easy!
fun!
Super easy to install and low land impact. I just wish it were a two way zip line.
