The Water Log Kit allows you to make any configuration or size water log track you desire. The system is very low Li and huge tracks can be created which are under 75 Li total. The main track Image in this ad is only 53Li. The lower track image is only 115 Li!
The Water Log kit is a set of waterways including straights, curves, lifts, drops and even a double spiral drop. It also includes a water log rezzer, support frames and a waypoints HUD to record the route for the water log notecard.
The track in this ad was set up in less than 20 minutes!
Optional items include a set of steps to get up to the water log and a giant splash prim to place at key locations around your water log system, curves, the bottom of hills, etc
The water log will travel around the track until the last rider stands up. The water log rezzer will always have a water log waiting for riders. The system can support as many water logs traveling around the track as you like, only limited by the amount of avatars that can be in the sim at the same time.
As soon as one water log is on its way, a new water log will rez for the next rider(s).
The water log kit consists of these low land impact components:
5Li - a water log rezzer Y section to rez water logs and have them waiting for riders
5 Li - water log car for up to four riders
1 Li - straight sections: 3m, 5m, 10m, 20m, 30m, 40m, 50m and 60m long
1Li - support frames for the straights and curves
1Li - 90 degree left and right curves
1Li - 45 degree left and right curves
2Li - belt lift to raise the track up approximately 20 meters - the track parts and waypoint balls can be unlinked so you can adjust the height.
1Li - support frames for the 45 degree track
2Li - 21.5 degree ramp down section which matches the height of the belt lift to go back down
1Li - support frames for the 21.5 degree track
1 Li - a double spiral that when stacked matches the 20m height to go back down
10Li - steps to get up to the log ride
1Li - a giant water splash prim to place in key locations
- a touch to delete all waypoint balls device
- a global waypoints listen HUD that you use to touch the green balls on the track sections to make the unique route for the water log to follow
The components of the guided tour system allow COPY and MODIFY, but NO TRANSFER; Scripts are COPY ONLY.
Therefore, not only can you alter the appearance of the water log, track pieces and rezzer, but you can also
create as many water log tracks as you want. It can cross sim lines too!
- Build any layout you want quickly and easily
- Low Land Impact Mesh - most parts are only 1L1
- Crosses Sim lines
- Fully Programmable routes use touch points and HUD
- Water Splashes can be added anywhere
