[Jammin] Wooden Pier Set - C/M/T Versión 2

Please Note: A full permissions version of this product is also available.

Viewing In-World is highly recommended - see the link below.

A set for creating wooden piers, completely modular to enable any shape you desire. Advanced materials have been fully utilized to create wet wood effects of varying degrees.

Version 2: Snow material/texture sets and tweaked mesh components.

2 assembled structures are included, to be used as-is, modified, or simply as guides for assembly of your own.

Both components are less than 1 Land-Impact each. Link together wherever possible to save on prims.

Very easy setup, designed to snap together at 4m intervals, but also completely scalable to fit as needed.

Designed so that the top surface can sit at varying levels above water, there are 4 material setups for the sides - snow-covered (new in V2), dry, half-wet, and full-wet, and 3 for the top - snow-covered (new in V2), wet, and dry.

Please note, the 'pier top' mesh is a single-sided plane. If you need to be able to see the underside of your pier, this mesh can be replaced with a rectangular prim to give you a top and bottom face. Alternatively, use two top meshes, flipping the bottom upside down. This will be higher in LI than using a single prim, but you may find it easier to set up.

----
Thanks for visiting Jammin - you won't be disappointed! IM or notecard IvanBenjammin if you have any trouble or questions.