LitCedarTree

The Lit Cedar Tree

This tree is designed to simulate blinking lights on a Cedar Tree. The tree contains two images and one script. The two images are those of a tree lit with lights and one with lights but not lit. The script is designed to swap the images making the tree look lit. It also adds some glow/lights spheres to the tree and allows the tree to sync to other trees.

Instructions:

By first rezzing the tree, the default setting is BLINK mode which has a default to blink every 2 seconds. There are three modes. SYNC, BLINK, and PAUSED.

SYNC Mode: Syncs with a single tree in BLINK mode. More than one tree in BLINK Mode will mess up the SYNC
BLINK Mode: Used to set a timer for the tree to blink at. Also sends out a message for other trees to blink with it.
PAUSE Mode: Paused the tree in it's current state.

To change settings:

- If tree is in SYNC or BLINK mode, left clicking the mouse or touching will put it in PAUSED mode.

- Clicking and holding the left mouse button while the tree is in PAUSE Mode will move the tree from SYNC mode to how many seconds you want the tree to cycle. Watch top of tree for information.

- Clicking the tree quickly while in PAUSE mode will put the tree in SYNC Mode.

NOTES:

- Tree in SYNC mode needs another tree to sync off of. The tree will sync off a tree with it's BLINK mode set.

- DO NOT have more then one tree set to BLINK mode if you are using the SYNC mode on any of your trees.

######Other Permissions #######
- Script C/No M/No Transfer
- Images C/No M/No Transfer
- Notecard C/M/T